Purpose

Oven offers stable and reliable temperature environment of testing space for preheating dryness, qualitative change physics and chemical change requirement, is suitable widely used for rubber plastic materials, adhesive tape, food pharmaceuticals, daily-used chemical and other industries.

Structure

1.Inner dimensions: 120 (W) × 120 (H) × 100 (D) ± 25px;

2.The controller is located in the machine table side, double doors open from the right and left;

3.Made of stainless steel mirror within the thickness 1.0mm;

4.Outer material is thick SECC steel ≥1.2mm powder coating processing;

5.Insulation made of high density glass wool 100K thick 100mm, good heat insulation, to ensure maximum temperature insulation.

6.Two stainless steel grid (mesh-shaped);

7.The packing density of the material for high temperature silicone anti-strip;

8.Configuration activities and fixed casters feet.

Control system

1.PID microprocessor temperature control, automatic calculation, PV / SV display at the same time, key set, at room temperature can be set to any temperature between the maximum temperature (Taiwan brand);

2. timer setting: 99.9 seconds -999 (selectable set the hours, minutes, seconds)

a. continuous use

b. temperature to time, time to cut off the heating current (end alarm)

3. Temperature  CA (K) TYPE thermal head;

4. output :3-32V;

5. the current controller to control the power output from the solid state relay, temperature controlled by PID microprocessor contact output, automatically adjusts the output signal proportional to precisely control the temperature overshoot accuracy (Taiwan Yangming);

6. stainless steel heater

7. temperature range RT ~ 200 ℃

8. heating rate: RT-100 ℃ for about 15 minutes

9. accuracy: ± 1 ℃

10. inside temperature distribution uniformity: ± 4 ℃ (no load)

Air supply system

1. Forced air circulation, air source is wind wheel motor cycle driven by electric heaters, hot air from the duct to the oven interior, and will use hot air suction duct become once again circulating air source heating, thereby reducing small energy consumption and to ensure uniformity of temperature inside, the door is open when the temperature drop caused, but also air circulation system can be quickly returned to working condition temperature.

2. The long axis of the motor for high temperature type, power 1hp / 50Hz (Taiwan).

3.10.5 Inch wind turbine wheel for multi-leaf type.

4. Built with adjustable wind deflector plate.

5. Rear air inlet, there are two air vents, exhaust volume adjustable.

Power supply

Voltage: 380V three-phase power: 8KW

Safety system

1.over-temperature protection system: When the temperature is out of control due to external causes, the system automatically stops the machine when the supply exceeds the set temperature of 10 degrees, so as to protect the safety of your products and machinery;

2, fuses and overcurrent protection system: When the voltage is too high or due to other causes beyond the power of the machine when normal power, the system will automatically power off to protect the whole of the industrial components are not damaged;

3.motor overheat protection to prevent motor damage caused by overheating of the motor phase sequence protection.